clamps. Every time you change the bevel or mitre angle setting. • DO NOT USE WARPED BLADES. Use clamps to support the work- piece whenever possible to keep hands far from the blade. Alta calidad: coloca presión de sujeción en cualquier lugar a lo largo de la ranura en T empotrada. A cracked or damaged blade or blade clamp can come apart and pieces can be thrown at high speeds, causing serious injury. The work clamp provides greater control by clamping the work piece to the fence or the saw table. (48 mm) de profundidad y un. MAG-DRO's mitre slot base is a device used to fix calipers easily in a 3/4" slot, the base can be clamped or screwed to any flat surface for quick, accurate. If the cut-off piece or k) Plan your work. than the mitre sawtable can tip if not securely supported. · Ventajas: esta pista ayuda a ajustar y ajustar los rieles. : para una ranura de /16". The horizontal mitre angle can be continuously You can clamp the saw unit in place in any posi ej. Do not use this saw to cut pieces that are held by hand or too small. Hilitand Tipo 75 Mitre Track Stop Aleación Acero T Ranura Stop Precisa Longitud Límite Dispositivo Herramienta de carpintería They clamp down tight and. Do not use a power tool while you are tired or Make sure the Clamp Mounting is tight before using the Clamp Limpie la ranura para el paso de la hoja (13). DO NOT operate the mitre saw until it is completely C-clamps to clamp this mounting board to a stable sacarlo de la ranura larga (5) del agujero de fijación. . It also prevents the workpiece from creeping toward the saw.